Microprocessor And Heat Sink; Figure 4-22. Microprocessor Configuration - Dell 6100 Service Manual

4-22 Dell PowerEdge 6100/200 System Service Manual

Microprocessor and Heat Sink

The computer may have up to four microprocessors installed. For more infor-
mation about microprocessors, see "Upgrading the Microprocessor or Installing
Additional Microprocessors" in Chapter 8, "Installing System Board Options"
of the Installation and Troubleshooting Guide.
microprocessor
socket

Figure 4-22. Microprocessor Configuration

1. Remove the support panel and the appropriate microprocessor module.
2. Remove the microprocessor securing clip from the microprocessor/heat
sink assembly.
WARNING: The microprocessor chip can get extremely hot during
system operations. Be sure the chip has had sufficient time to cool
before touching it.
CAUTION: Never remove the heat sink from a microprocessor
unless you intend to remove the microprocessor. The heat sink is nec-
essary to maintain proper thermal conditions.
clip
heat sink
thermal pad
(bonded to heat sink)
microprocessor
pin-1 corner of socket
front tab