Figure 4-9. Hard-Disk Drive Removal - Dell 6100 Service Manual

Dell poweredge 6100 servers: service manual

Hide thumbs Also See for 6100:

Table of Contents

4-10

Dell PowerEdge 6100/200 System Service Manual

hard-disk drive

connector

screw (4)

Figure 4-9. Hard-Disk Drive Removal

5. Remove the four mounting screws that attach the hard-disk drive to the

carrier.

6. Disconnect the hard-disk drive from the connector on the back of the

carrier, and lift the drive from the carrier.

CAUTION: When disconnecting the hard-disk drive from the con-

nector, grasp the connector, not the cable, to avoid damaging the

connector.

NOTE: Dell recommends that you use only drives that Dell has tested and

approved for use with the SCSI backplane board.

After you replace the drive and reinstall the carrier in the bay, turn on the

system, if applicable. The online indicator lights, indicating power is being sup-

plied to the hard-disk drive. With the controller connected, the activity indicator

lights when the controller spins up the drive.

carrier

Table of Contents

Poweredge 6100/200