Table 1-3. Microprocessor Module Jumper Descriptions
Jumper
Setting
J101
J105
J106
jumpered
SCSI Backplane Board
Ultra/Wide SCSI
cable connector (SCSI)
power input
connector (POWER)
server-management bus connector
(SERVER MANAGEMENT)
control (front) panel connector
(CONTROL PANEL)
Figure 1-17. SCSI Backplane Board
Description
(default)
Microprocessor is not installed in
adjacent slot. This jumper is useful
only when you are using in-target
probe (ITP).
Microprocessor is installed in
adjacent slot.
(default)
200/66 MHz microprocessor
installed. Do not change.
(default)
Microprocessor is not installed in
adjacent slot. This jumper is useful
only when using ITP.
Microprocessor is installed in
adjacent slot.
unjumpered
6 SCA-2 compatible SCSI
connectors (SLOT n ID= n ,
on other side)
System Overview
1-21