Install A Large Output Hopper - DataCard SD260 Installation And User Manual

Install a Large Output Hopper

The output hopper included with
the printer holds about 25 cards.
The printer can be used with an
optional large output hopper that
holds up to 100 cards.
The large output hopper kit
includes two base sections and a
large output hopper. The two base
sections are the same; turn them
back to back to use them. Each base has hooks, marked by green circles, to attach
it to the printer base.
You can remove the standard hopper and attach the large output hopper without
using tools.
Follow the steps in this topic to attach the
printer to the bases, and to install the larger
output hopper.
1.
Position one base section with the open end
facing the back of the printer.
2.
Lift the printer over the base section.
3.
Align the tabs in the base with the slots in
the bottom of the printer.
4.
Push up (a) to insert the four tabs in the slots and then
push the base forward (b) to lock it to the printer.
5.
Position the other base section with the opening to the
front of the printer.
151