Install The Finishing Materials; Attach The Safety-In-Operation Warnings - Superior Fireplaces DRT4000-C Series Installation And Operation Instructions Manual

Innovative Hearth Products
DRT4000-C & DRT4200-C Series Direct-Vent Gas Fireplaces
Figure 35B - Lower Barrier Until it Seats into the Barrier Support Bracket.

Install the Finishing Materials

22.
1. Complete finished interior wall.
NOTE: To install the fireplace facing flush with the finished wall, position framework to accommodate the thickness of
the finished wall.
Figure 36 - Combustible Wall Framing
NOTE: See Cold Climate Insulation on Page 11 and Vent Termination Clearances on Pages 13-14.
Attach the Safety-in-Operation Warning Labels
23.
1. Attach the furnished safety instruction labels at all fireplace operation and control points (Page 50).
NOTE: The installer MUST ensure these warnings are properly attached during installation. The warning labels are a
critical means of informing consumers of safe operation practices.
Spline
This Area
Must Remain
Clear of
Combustible
Materials
1" Min.
Combustible
(26 mm)
Finished Wall
Materials
Stand Off
Must Be Bent
To Vertical
Position
Standoff
Provides
Space From
Combustible
Top Of
Materials
Appliance
4" Clearance
Minimum
Hood
Barrier Support Bracket
3"
(77 mm)
Installation
901032-00B, 07/2020
49