Initialize Remote Control (Drt4200-C Series Only) - Superior Fireplaces DRT4000-C Series Installation And Operation Instructions Manual

Innovative Hearth Products
DRT4000-C & DRT4200-C Series Direct-Vent Gas Fireplaces
15. Initializing the Remote Control System (DRT4200-C models)
3. After completing fireplace installation, initialize the remote control system before operating the fireplace.
4. Insert the three (3) provided AAA batteries into the battery bay in the transmitter, taking care to correctly align polarity
( + / - ).
5. Insert the four (4) provided AA batteries into the receiver battery bay (behind the wall switch plate), taking care to cor-
rectly align polarity ( + / - ).
6. On the receiver, place the three-position slider switch in the REMOTE position (Figure 33A).
7. On the receiver front cover, insert the end of a paper clip (or other similar object; not provided) into the hole marked
"PRG."
The receiver will "beep" three times to indicate it is ready to synchronize with the transmitter.
8. On the transmitter, press the ON button. The receiver will "beep" four times to indicate acceptance of the transmitter's
command (and set the receiver to the transmitter's specific code). The system is now initialized.
The remote control system provides remote operation of the following fireplace functions:
• Primary burner ON/OFF
• Flame height and heat output adjustment (six levels)
The receiver accepts commands via radio frequency from the transmitter and does not require line-of-sight operation.
The slider switch on the receiver can be set to one of three positions:
• ON (manual override)
• OFF (manual override)
• REMOTE (remote control)
See the fireplace Care and Operation Instructions for detailed instructions on using the remote control system to operate the fireplace.
Three-position slider switch
in REMOTE position
Figure 33A—Receiver (Wall Switch)
Fire hazard. Can cause severe injury or death. The receiver causes ignition of the appliance.
The appliance can turn on suddenly. Keep away from the appliance burner when operating the
remote system or activating manual bypass of the remote system.
Property damage hazard. Excessive heat can cause property damage. The appliance can stay
lit for many hours. Turn off the appliance if it is not going to be attended for any length of time.
Always place the transmitter where children can not reach it.
On
Remote
Off
PRG
UP/DOWN
Arrow Key
MODE Key
Figure 33B—Transmitter (Remote Control)
WARNING
CAUTION
Installation
901032-00B, 07/2020
LCD Display
ON/OFF Key
ROOM
TEMP.
Key
45