Superior Fireplaces DRT4000-C Series Installation And Operation Instructions Manual page 42

Innovative Hearth Products
DRT4000-C & DRT4200-C Series Direct-Vent Gas Fireplaces
Electronic Wiring DRT4200-C series
One of the following optional controls must be used:
•
•
NOTE: Electronic models must be connected to the main power supply.
1. Route a 3-wire, 120 Vac, 60 Hz, 1 ph power supply to the fireplace junction box.
2. Remove the electrical inlet cover plate from the side of the unit by removing the plate's securing screws (Table 12,
3. If unit is not supplied with a strain relief, remove the cover plate knockout. Then, feed the power supply wire through
4. Connect the black power supply wire to the lower outlet's red pigtail lead (Figure 29, Page 40). Connect the white
5. Connect the ground supply wire to the pigtail lead attached to the outlet's green ground screw. Restrain the inlet
6. The wall switch receiver for the Total Comfort Control™ remote control system connects directly to the gas valve,
7. After the wiring is complete, replace the cover plate.
Figure 30B - Wiring Diagram—Electronic Gas Valve DRT4200-C series
Schematic Representation Only
COLOR CODE:
B = BLACK
BB = BROWN W/BLACK STRIPE
BG = BROWN W/GREEN STRIPE
BL = BLUE
BR = BROWN
G = GREEN
GY = GRAY
O = ORANGE
R = RED
W = WHITE
Y = YELLOW
Models w/o pressure switch have
these connectors plugged together
Optional Circulation
42
ON/OFF Control
Remote Control
Page 18).
the knockout opening and into the unit junction box.
power supply wire to the outlet's common terminal.
power lead per NEC or local codes.
stepper motor, and fan control module with an umbilical cord wiring harness. Install a junction box (not provided)
on the wall adjacent to the appliance, within reach of the remote system umbilical cord wiring harness.
Battery Holder w/Switch
Battery Holder w/Switch
ON/ Remote
/OFF
Main Wire
Harness
Y
BR
G
Y
Battery Holder
Wire Harness
Air Pressure Switch
GY
Power Vent Only
Blower
Optional Variable Light
BB BG
B
W
G
885 Valve
ON/Remote/Off
B
O
R
BL
G
W
R
B
Reset Switch
BL
"see instructions"
R
O
GY
B
WH
BR
BB
IPI Pilot
Pilot Tube
Split Flow
B
Control Module
Fuse
B
W
BG
Installation
901032-00B, 07/2020
Flame Sensor
Spark Electrode
B
Ground Y
G
Main Power Cord