Superior Fireplaces DRT4000-C Series Installation And Operation Instructions Manual page 60

Innovative Hearth Products
DRT4000-C & DRT4200-C Series Direct-Vent Gas Fireplaces
Install the Logs, Volcanic Stone, and Glowing Embers
• Turn OFF all gas and electricity to the appliance before installing the volcanic stone, embers, and logs.
• Do NOT install the logs until the appliance has been completely installed, the gas line connected and
tested for leaks, and the initial burner operation has been confirmed.
• Use of an unapproved log set in the fireplace will void the warranty and will result in incomplete
combustion, sooting, and poor flame quality.
• Logs get very hot and remain hot for up to one hour after the gas supply is turned OFF. Handle the logs
only when cool.
• This appliance is not designed to burn wood. Any attempt to do so could cause irreparable damage to
appliance and prove hazardous.
• If the logs are not installed according to these instructions, improper combustion could occur. This could
result in the excessive production of soot and/or the colorless, odorless, toxic gas carbon monoxide (CO).
NOTE: It is important to ensure proper log placement per the manual when installing these units. Verify pilot flame is
not obstructed. See Verifying Appliance Operation on Page 44.
NOTE: If applicable, install the firebox liner before placing the stone. Logs can be installed after the volcanic stone.
Installing the volcanic stone, and glowing embers
1. If necessary, remove the glass door (Pages 63-64).
2. Spread the decorative volcanic stone in a pleasing pattern on the firebox floor along the slope and to the back
3. Separate and fluff the glowing embers into pieces approximately the size of a quarter (Figure 41).
Figure 40 - Install volcanic stone
4. Position the separated glowing embers over the small holes on the burner surface as shown in Figure 42. Do
Figure 42 - Install glowing embers
NOTE: Enough glow-
ing ember material is
provided for several
applications. For best
glowing effect,
NOTE:
replace the ember
DRT2000
material annually.
models; Plac-
ing embers in
this area will
reduce glow
on middle log.
60
right and left sides of the burner (Figure 40).
NOTE: Do not place stone on the burner.
Volcanic
Stone
NOT cover the large burner slots.
Top View
Glowing Embers
WARNING
Figure 41 - Separate glowing embers
Figure 42A - Install glowing embers
901032-00B, 07/2020
Glowing Embers
Operation