Table of Contents
Advertisement
- DRI2530TEN Models Only
Operating Options
Burner ON/OFF Switch Installation:
The burner ON/OFF switch on your gas appliance is used to turn the burner
on and off. This switch can be installed in the hole in the right side of
the top surround panel (see Option 1) or in the hole in the control panel
in the control compartment (see Option 2). Note: Wire connections on
provided switch are reversible.
Option 1 - Switch Installation On Surround Panel (see Figure 16) -
1. Disconnect the switch from the extension wires to which it is attached,
then unscrew the plastic nut from the back side of the switch.
2. Insert the switch into the hole located on the upper right side of the
surround then reinstall the plastic nut onto switch.
3. Install the three plastic adhesive backed wire restraints (found in the
supplied hardware kit) to the backside of the surround panel. Route
the switch wires through these restraints and up to the switch. Care
should be taken to ensure the wires do not come in contact with the
hot surfaces of the fire box. Reconnect the wires to the switch.
Option 2 - Switch Installation On Control Panel (see Figure 17) -
Note: It will aid in the ease of installation if you remove the control panel
(see Figure 15). The panel has keyhole slots where it mounts to the base.
Loosen the two nuts securing the panel using 3/8" wrench. Carefully
move out the panel far enough to access the back. Do not pull the panel
out too far or it may pull apart some of the connections.
1. Carefully cut out the burner switch hole in the control panel label.
2. Disconnect the switch from the extension wires to which it is attached,
then disconnect these wires from the green and white wires on the
on the main harness. The extension wires are no longer needed and
can be removed from the appliance.
3. Unscrew the plastic nut from the back side of the switch. Insert the
switch into the hole on the control panel then reinstall the plastic nut
onto switch.
4. Connect the green and white wires from the main wire harness to the
switch. Care should be taken to ensure the wires are positioned so they
will not come in contact with the hot surfaces of the fire box. Reinstall
control panel, if necessary, and verify there are no wires coming in
contact with the fire box.
O N
F L A
M E
H E IG
H T
A U
O N
P IL O
i
B L O
W E R
O FF
Figure 15 - Control Panel Removal
B U R
N E R
Nut
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
OPTION 1
Figure 16 - Burner ON/OFF Switch On Surround
OPTION 2
H EI G H
T
FL AM E
Figure 17 - Burner ON/OFF Switch On Control Panel
Optional GT Remote Control Installation - An optional remote control
can be used to supplement the burner ON/OFF switch (see Page 36 for
ordering information). See instructions provided with remote control kit
for installation and operation instructions.
Face Installation - All Models
The faces come with hooked brackets. To install the face, hang the hooked
brackets on the surround brackets (See C in Figure 14).
Surround
Panel
ON
BU RN ER
ON
OF F
AU TO
BL O W ER
PI LO T
19
Advertisement
Table of Contents
