Install The Wall Switch Receiver; Initialize The Remote Control System; Attach The Safety-In-Operation Warnings - Superior Fireplaces DRL3000 Installation Instructions Manual

Innovative Hearth Products
DRL3000 Linear Direct-Vent Gas Fireplaces
Figure 42 - Noncombustible Material with Bezel and Barrier
Clean
Face Frame
(removed first)
Surround
mounting
brackets

Install the Wall Switch Receiver

18.
1. When wall finish is complete, install the wall switch receiver in the previously installed junction box, and connect
the 2-wire terminal to the connector on the back of the receiver.
2. Install the receiver cover plate. Ensure the receiver switch is properly aligned with the switch cover

Initialize the Remote Control System

19.
After completing the fireplace installation and before operating the fireplace, initialize the remote control system per
the instructions provided in the kit.
1. Insert the 3-volt battery into the battery bay in the remote control (Figure 43). Correctly align polarity (+/–).
2. Insert the (4) provided AA batteries into the receiver battery bay (Figure 43). Correctly align polarity (+/–).
Figure 43 - Remote and Wall Receiver Battery Compartments
Compartment
Attach the Safety-in-Operation Warning Labels
20.
1. Attach the furnished safety instruction labels at all fireplace operation and control points (Page 46).
NOTE: The installer MUST ensure these warnings are properly attached during installation. The warning labels are a
critical means of informing consumers of safe operation practices.
Requires 4-AA 1.5V
alkaline batteries
Remote
Control
Slide
Switch
3 Volt
+
Wall
Battery
Receiver
900079-02J, 05/2019
Two (2) Top
One (1) Top non
Non-combustible
-combustible
board
boards
Bezel and Barrier
Barrier
(added after Surround
(added after surround)
- not shown)
Figure 44 - Remote Control Transmitter
Installation
Burner ON/OFF
45