Table of Contents
Advertisement
Innovative Hearth Products
DRL6500 Linear Direct-Vent Gas Fireplaces
Figure 41 - Noncombustible Material with Bezel and Barrier
Clean
Face Frame
(removed first)
Surround mounting
brackets (provided
with surround kit)
Initialize the Remote Control System
After completing fireplace installation, initialize the remote control system before operating the fireplace.
1. Insert the three (3) provided AAA batteries into the battery bay in the remote control (Figure 43). Correctly align polarity (+/–).
2. Insert the (4) provided AA batteries into the receiver battery bay (behind the wall switch plate). Correctly align polarity (+/–).
3. Position the wall switch receiver three-position slider switch in the REMOTE position (Figure 42).
4. On the wall switch receiver cover plate, insert the end of a paper clip (or other similar small object) into the hole
marked PRG (Figure 47). The receiver will beep three (3) times to indicate it is ready to synchronize with the
Remote control.
5. On the remote control, press the ON button (Figure 43).
NOTE: The wall switch receiver will beep four (4) times to indicate acceptance of the remote control command
(and set the Receiver to the Transmitter's specific code).
6. See Page 55 for information on remote control operation.
Figure 42 - Wall Receiver Switch
Three-position slider switch in REMOTE
position
On
Remote
Off
PRG
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Figure 43 - Remote Control Transmitter
UP/DOWN
Arrow Key
MODE Key
Installation
900077-00, 01/2018
One (1) Top non
-combustible
board
Clean
Face Frame
(removed first)
Bezel and Barrier
(added after Surround
- not shown)
LCD Display
ON/OFF Key
ROOM
TEMPERATURE
Key
45
Advertisement
Table of Contents
