If You Suspect A Failure Then Do The Following; Cannot Send A Fax Correctly - Konica Minolta bizhub 306 Quick Manual

4
4.9

If you suspect a failure then do the following

If fax transmission or reception fails, check the corresponding item in the following table.

Cannot send a fax correctly

Fax status
The original is not scanned.
The original is scanned oblique-
ly.
An unclear image has been re-
ceived at a destination.
A blank image has been re-
ceived at a destination.
Cannot send a fax automatical-
ly.
4-14
If you suspect a failure then do the following
Major cause
Is the original too thick?
Is the original too thin or small?
Is the Original Glass dirty?
Does the Lateral Guide match
the original width?
Is the original positioned correct-
ly?
Is the Original Glass dirty?
Is the original text too faint?
Is there a problem with the line
status or destination fax?
Is the original loaded, turning
down the original side to be
sent? (in use of ADF)
Was the number called correct?
Did you call a telephone-dedicat-
ed number?
Was there any problem at the re-
cipient end? (Paper out, Auto RX
is disabled, the power is not
turned off, and other causes)
Correction action
Load the original onto the Origi-
nal Glass. For details, refer to
[User's Guide Copy].
Load the original onto the Origi-
nal Glass. For details, refer to
[User's Guide Copy].
Wipe the Original Glass with a
soft, dry cloth.
Adjust the Lateral Guide to the
original width. For details, refer
to [User's Guide Copy].
Position the original correctly.
For details, refer to [User's Guide
Copy].
Wipe the Original Glass with a
soft, dry cloth.
Specify the scanning density. For
details, refer to [User's Guide
Fax].
Make a copy in this machine to
check the result. If a copy image
is clear, send a fax again.
Load the original, turning up the
original side to be sent. Then,
send the original again. For de-
tails, refer to [User's Guide
Copy].
Check the number.
Check the number.
Check with the sender.
bizhub 306/266
4.9