Identity Code; Configuring The Touchpanel - Crestron CT-1000 Operation Manual

Touchpanels
Main Menu
6 • Series 1000 Wall-Mounted Touchpanels
NOTE: When daisy-chaining Cresnet units, strip the ends of the wires carefully to
avoid nicking the conductors. Twist together the ends of the wires that share a pin on
the network connector, and tin the twisted connection. Apply solder only to the ends
of the twisted wires. Avoid tinning too far up the wires or the end becomes brittle.
Insert the tinned connection into the Cresnet connector and tighten the retaining
screw. Repeat the procedure for the other three conductors.
NOTE: For larger networks (i.e., greater than 28 network devices), it may be
necessary to add a Cresnet Hub/Repeater (CNXHUB) to maintain signal quality
throughout the network. Also, for networks with lengthy cable runs, it may be
desirable to add a hub/repeater after only 20 network devices.

Identity Code

Every equipment and user interface within the Cresnet system requires a unique
Cresnet identity code (NET ID). These codes are a two-digit hexadecimal number
from 03 to FE. Refer to "Interface Menu" on page 9 for instructions on setting the
unit's NET ID. The NET ID of the unit must match the NET ID specified in the
SIMPL Windows program. Refer to "Setting the Net ID in Device Settings" on page
17 for details of the SIMPL Windows procedure.

Configuring the Touchpanel

NOTE: The only connection required to configure the touchpanel is power. Refer to
"Hardware Hookup" on page 10 for details.
To configure the unit, it may be necessary to access a series of setup screens prior to
viewing run-time screens that are loaded into the touchpanel for normal operation.
The Main Menu for configuring the touchpanel appears when a finger is held
(approx. 5 seconds) to the touchscreen as power is applied. Remove your finger
when the message "SETUP MODE" appears on the touchscreen. Holding a finger to
the touchscreen for five seconds after the "SETUP MODE" message is displayed
sets the brightness to high and the contrast to a default level.
NOTE: "SETUP MODE" may also be entered by sending the respective command
from the Functions pull-down of the Crestron Viewport.
Upon entering SETUP MODE, the Main Menu, shown to the left, displays four
buttons: SAVE SETUP AND RUN PROGRAM, DIAGNOSTICS, TOUCH
SCREEN CALIBRATION, and SETUP.
The SAVE SETUP AND RUN PROGRAM button verifies that all of the setup
information has been saved to EEPROM and displays the main page that has been
programmed into your system. The remaining buttons on the Main Menu open other
menus, which are discussed in subsequent paragraphs.
Crestron CT-1000 & LC-1000
Operations Guide – DOC. 5813B