Hardware Hookup - Crestron CT-1000 Operation Manual

Touchpanels
Sound Menu
Diagnostics Menu
10 • Series 1000 Wall-Mounted Touchpanels
Sound Menu
The SOUND button on the Setup Menu is used to display the Sound Menu, shown to
the left. Use this screen to activate audible key clicks and sounds (recorded as WAV
files) on each individual touchpanel. This feature is a useful feedback tool or can be
used to capture that custom interface.
Confirmation of a button press on a touchpanel is acknowledged by an audible click
assuming this feature is enabled. To enable this feature, verify that the KEYCLICK
ON button is active (white text on dark gray background (for LC-1000) or red text
(for CT-1000)). An active KEYCLICK OFF button disables the feature.
NOTE: If keyclick is enabled on a touchpanel, each press of the touchpanel results
in an audible click. It may be desirable to conceal the keyclick sound for certain
buttons (eg., if the button triggers playing of a WAV file). Using VT Pro-e, the panel
designer has the option to suppress the keyclick on a button-by-button basis from the
"Button Properties" window.
WAV file audio messages can provide that custom interface with a touchpanel,
assuming this feature is enabled. To enable this feature, verify that the SOUNDS ON
button is active (white text on dark gray background (for LC-1000) or red text (for
CT-1000)). An active SOUNDS OFF button disables the feature.
Volume of the audible clicks and sounds is controlled with the VOLUME UP and
VOLUME DOWN buttons. The VOLUME LEVEL numerical value, represented
by xx in the illustration, can range from 0 (no volume) to 11 (loud volume). The unit
is factory set with the keyclicks and sounds on.
Select the RETURN button located on the Sound Menu to return to the Setup Menu.
Diagnostics Menu
The DIAGNOSTICS button from the Main Menu should only be used under
supervision from a Crestron technical support representative during telephone
support. The options available from the Diagnostics Menu, shown to the left, are
numeric in nature and their interpretation is beyond the scope of this manual.
NOTE: Pressing the ABOUT button reveals the touchpanel firmware version.

Hardware Hookup

CAUTION: Do not remove the tape that covers the photosensor. Doing so can short
the board and damage the touchpanel.
CAUTION: Do not apply excessive pressure to the touchscreen display during
installation. Doing so can crack the screen and damage the touchpanel.
Make the necessary connection called out in the illustration that follows this
paragraph. Refer to "Network Wiring" on page 5 before attaching the 4-pin
connector.
Crestron CT-1000 & LC-1000
Operations Guide – DOC. 5813B