Table of Contents
Advertisement
Crestron CT-1000 & LC-1000
Timeout Menu
Interface Menu
Operations Guide – DOC. 5813B
Timeout Menu
The touchpanel display can be turned off (standby mode) when not in active use.
Select the TIMEOUT button on the Setup Menu to reveal the Timeout Menu,
shown to the left. This setting turns the display off when the touchpanel is inactive
for a specified time (shown in minutes). When the touchpanel is pressed, the last
screen to be displayed reappears. A two minute DISPLAY TIMEOUT is shown in
the illustration. Minutes can vary from 0 to 120, where 0 disables the timeout.
DECREASE << TIMEOUT and INCREASE >> TIMEOUT buttons decrease and
increase the timeout, respectively. Select the RETURN button located on the
Timeout Menu to save the timeout setting and return to the Setup Menu.
Interface Menu
The touchpanel communicates with a control system to activate other controls or to
display feedback from components within the system. The communication interface
must be correctly specified or communication will not occur. To set communication
parameters select the INTERFACE button located on the Setup Menu and display
the Interface Menu, shown to the left.
The Cresnet network identity number (CRESNET ID) is displayed on the Interface
Menu. CRESNET ID is the two-digit hexadecimal number shown as 03 in the figure.
NET ID is factory set to 03 (default). The hexadecimal number can range from 03 to
FE and must correspond to the NET ID set in the SIMPL Windows program of the
Cresnet system. Matching IDs between touchpanel and SIMPL Windows program is
required if data is to be successfully transferred.
Two side-by-side buttons beneath the hexadecimal display, CRESNET ID <<
DOWN and CRESNET ID >> UP, decrease and increase the CRESNET ID by one,
respectively.
The touchpanel usually communicates with a Cresnet system. Occasionally the
touchpanel can be used in a local demo mode where it merely displays various
menus, but does not communicate with Cresnet system. In local mode, the directory
buttons change pages, but buttons requiring feedback do not work. Two centrally
located buttons on the Interface Menu, LOCAL MODE and CRESNET MODE,
determine communication mode. Select LOCAL MODE to set the touchpanel into
demo mode and CRESNET MODE for normal Cresnet communication mode.
Selected buttons have white text on dark gray background (for the LC-1000) or red
text (for the CT-1000). Communication mode is factory set to CRESNET MODE.
Select the RETURN button located on the Interface Menu to return to the Setup
Menu.
Series 1000 Wall-Mounted Touchpanels • 9
Touchpanels
Advertisement
Table of Contents
