Appendix: Early Production Units - Crestron CT-1000 Operation Manual

Touchpanels

Appendix: Early Production Units

34 • Series 1000 Wall-Mounted Touchpanels
Early production units ship with two mounting brackets (and other parts) that
allowed the low-voltage touchpanel to be installed directly into a mounting surface.
These units are provided with mounting hardware and accessories, as shown in the
table after this paragraph.
Series 1000 Supplied Mounting Hardware and Accessories (Early Production Units)
ITEM
Mounting Bracket
Template
Screw, Pan Phillips
Network Connector
Plastic Buttons
Plastic Cover
If these parts are supplied with the touchpanel and a direct mounting option is
preferred, complete the following mounting procedure in the order provided. The
only tools required are masking tape (or equivalent), a gypsum board saw (or
equivalent), and a #2 Phillips tip screwdriver.
1. Locate an area on the wall that is free of miscellaneous wiring and
studs.
2. Make a small hole near the middle of the designated site; verify that the
location is suitable.
3. Using masking tape (or equivalent), fasten cutout template (40054,
supplied) to mounting surface; verify that the template is level.
Cutout Detail of Supplied Template
TEMPLATE - OV40054-1
( NOT FOR BB-1000 BACK BOX )
CUT ALONG LINE
CRESTRON
REMOTE CONTROL SYSTEMS
NOTE: The actual cutout dimensions (shown as dashed lines) are 4
5
(106 mm) wide by 4 / inch (109 mm) high. However, Crestron recommends that
16
the supplied template be used to avoid error.
Crestron CT-1000 & LC-1000
PART NUMBER
AY17517-1
OV40054-1
#4-40 x 1" LG
JHPS138SG04SR-1
SWCP28292-1
PLCV28207-1
FOR LC-1000
AND CT-1000
Operations Guide – DOC. 5813B
QUANTITY
2
1
4
1
10
1
3
/ inch
16