Touchpanels
12 • Series 1000 Wall-Mounted Touchpanels
1. If the cover is attached, use a #1 Phillips screwdriver to loosen and
remove the four screws and cover plate.
Remove Cover Plate (BB-1000L Shown as Mounting Example - Drywall Not Shown)
2. Make the connection as described in "Hardware Hookup" on page
10.
3. Insert the touchpanel (without its faceplate) into the mounting
option and align the four screw holes.
4. Insert and tighten the four screws (finger tight and then using a #1
Phillips screwdriver, tighten an additional 1/8-turn).
5. Insert ten buttons. If the buttons are engraved, verify that the
placement of each button matches the programming.
6. Cover the mounted unit with the faceplate. Refer to the illustration
after this paragraph for guidance.
Crestron CT-1000 & LC-1000
Operations Guide – DOC. 5813B