Teledyne 300 Instruction Manual page 51

exiting calibration it is desirable to take a single instantaneous reading using the INST
mode. The table below summarizes the available sampling modes.
Mode
INST
AVG
MIN
MAX
Each parameter in this list can refer to a different (or the same) point, and can use a
different (or the same) sampling mode. For instance, you could create three parameters
which all measure the CO concentration for range 1 (the CONC1 parameter), but which
use the MIN, AVG, and MAX sampling modes. This permits you to record not only the
average concentration during the reporting interval, but the maximum excursions as well.
Like data channels, parameters also have properties which are listed in the table below.
Property
PARAMETER The parameter to sample
SAMPLE The sampling mode to use
MODE when reading this
parameter
PRECISION Number of decimal digits
The table below lists the data parameters initially defined. The entries in the Name and
Units columns are visible when editing and printing the data channel properties.
P/N 02163G Teledyne API Model 300 CO Analyzer Instruction Manual - Page 45
Sampling Modes
Records instantaneous reading
Records average reading during reporting interval
Records minimum reading during reporting interval
Records maximum reading during reporting interval
Parameter Properties
Description
Description
Initial
Setting
CONC1 Any of the parameters
listed in the table of
parameters shown
above
AVG Any one of the INST,
AVG, MIN, and MAX.
1 0 - 3
Setting Range