Teledyne 300 Instruction Manual page 31

Mode
SAMPLE x (1)
SAMPLE x (1)
ZERO CAL x (2)
SPAN CAL x (2)
MP CAL
SETUP xxx (3)
DIAG DAS (4)
DIAG I/O (4)
DIAG AOUT (4)
DIAG D/A (4)
DIAG TCHN (4)
The message field shows test measurements or warning messages. Tables 2.3 and 2.4
summarize the test measurements and warning messages and their meanings. Refer to
Sections 4.0 and 5.0 for detailed information on viewing test measurements and warning
messages and clearing warnings.
Test Message
TIME=xx:xx:xx
RANGE=xxxx PPM
STABIL=x.xxx PPM
CO MEAS=xxxxx MV
CO REF=xxxxx MV
MR RATIO=X.XXX
PRES=xxx IN-HG-A
SAMPLE FL=xxx CC/M
SAMPLE TEMP=xxx C
BENCH TMP=xxx C
WHEEL TMP=xxx C
BOX TEMP=xxx C
DCPS=xxxxxx MV
SLOPE=x.xxx
OFFSET=xx.x MV
P/N 02163G Teledyne API Model 300 CO Analyzer Instruction Manual - Page 25
SYSTEM MODES
Flashing indicates adaptive filter is on
Doing a zero check or adjust
Doing a span check or adjust
Doing a multi-point calibration
Configuring analyzer (sampling continues)
Data Acquisition configuration
Test digital I/O signals
Test analog output channels
Configure and Calibrate Digital to Analog converters
Configure Test Channel output
(1) x = A (auto)
(2) x = M (manual), A (auto), R (remote)
(3) xxx = software revision (e.g. A.9)
(4) diagnostic test modes
TABLE 2.2
TEST MEASUREMENTS
Current time-of-day (HH:MM:SS)
Analog output full-scale range
Standard Deviation of CO readings
Current V/F measure channel (mV)
Current V/F reference channel (mV)
Ratio of the Reference and Measure values
Absolute sample pressure - inches Hg
Sample flow through Analyzer (cc/min)
Temperature in the absorption cell
Internal box temperature (degrees C)
TABLE 2.3
Meaning
Sampling normally
Meaning
Optical Bench Temperature
Filter Wheel Temperature
DC power supply (mV)
Internal formula - Slope
Internal formula - Offset