Status/Control - Teledyne 300 Instruction Manual

WARNING MESSAGE CLEAR COMMANDS
Command
"W WSYSRES<CRLF>"
"W WRAMINIT<CRLF>"
"W WSOURCE<CRLF>"
"W WBHEAT<CRLF>"
"W WWHLTEMP<CRLF>"
"W WSMPFLOW<CRLF>"
"W WSMPRES<CRLF>"
"W WSMPTEMP<CRLF>"
"W WBOXTEMP<CRLF>"
"W WBNCHTEMP<CRLF>"
"W WDYNZERO<CRLF>"
"W WDYNSPAN<CRLF>"
"W WVFINS<CRLF>"

7.3 Status/control

This subset of messages is concerned with reporting the status of the Analyzer and
controlling the Analyzer remotely. Whenever the Analyzer does a calibration it issues a
report to the RS-232 output. The table on the following page summarizes the status
reports.
"C DDD:HH:MM IIII START ZERO CALIBRATION"
"C DDD:HH:MM IIII FINISH ZERO CALIBRATION"
"C DDD:HH:MM IIII START SPAN CALIBRATION"
"C DDD:HH:MM IIII FINISH SPAN CALIBRATION"
"C DDD:HH:MM IIII START MULTI-POINT CALIBRATION"
"C DDD:HH:MM IIII FINISH MULTI-POINT CALIBRATION"
"C DDD:HH:MM IIII START CALIBRATION HOLD"
"C DDD:HH:MM IIII FINISH CALIBRATION HOLD"
To do a remote adjustment via the RS-232 interface, the host computer should issue a
message with the following format:
The commands are summarized in the table below:
P/N 02163G Teledyne API Model 300 CO Analyzer Instruction Manual - Page 59
SAMPLE PRESSURE WARNING
TABLE 7.2
STATUS REPORTS
Report
TABLE 7.3
"C COMMAND<CRLF>
Warning Message Cleared
SYSTEM RESET
RAM INITIALIZED
SOURCE WARNING
BENCH HEAT SHUTDOWN
WHEEL TEMP WARNING
SAMPLE FLOW WARNING
SAMPLE TEMP WARNING
BOX TEMP WARNING
BENCH TEMP WARNING
CANNOT DYN ZERO
CANNOT DYN SPAN
V/F NOT INSTALLED