Table of Contents
Advertisement
the front panel. It should read the same as the version number that was located on
the top right corner of the label on the PROM.
8.
Re-enter any non-default settings such as RANGE or ASEQ. Re-enter the CONC
value in the CAL menu. Check all settings to make sure that expected setup
parameters are present.
9.
Re-calibrate the analyzer so that the default slope and intercept are overwritten
with the correct values.
P/N 02163G Teledyne API Model 300 CO Analyzer Instruction Manual - Page 96
Advertisement
Table of Contents
Troubleshooting
