Xilinx Virtex-6 FPGA Getting Started Manual page 48

Modifying the Virtex-6 FPGA Targeted Reference Design
4.
X-Ref Target - Figure 42
5.
X-Ref Target - Figure 43
48
environment selected. The Setup Information file (xraw.inf) is also available in
the same directory.
Note:
The XAUI and Raw Data drivers are not required to be recompiled because only the
Vendor ID was changed. The
software sections need to be modified.
Create the recompiled driver package:
After all the drivers are compiled, create a folder called compiled_drivers. In this
folder, do the following:
a. Make a folder called xdma and populate it with xdma.sys (type - System File) and
xdma.inf (type - Setup Information) from the DMA driver compiled area.
b. Make a folder called xaui and populate it with xaui.sys (type - System File) and
xaui.inf (type - Setup Information) from the XAUI driver compiled area.
c. Make a folder called xraw and populate it with xraw.sys (type - System File) and
xraw.inf (type - Setup Information) from the Raw Data driver compiled area.
d. Copy the GUI executable from the v6_pcie_10Gdma_ddr3_xaui_axi/
windows_driver/xpmon folder.
e. Copy WdfCoInstaller01009.dll from the
v6_pcie_10Gdma_ddr3_xaui_axi/windows_driver/utils folder and
place it under the xdma, xaui, and xraw folders.
The folder hierarchy appears as shown in
Figure 42: Compiled Driver Directory Organization
Uninstall previous drivers:
If previous drivers are installed in the system, they need to be uninstalled. To uninstall
previous drivers, run x_v6_trd_setup.exe. InstallShield asks for confirmation of
driver install. Click OK (Figure
Figure 43: Confirm Driver Uninstall
www.xilinx.com
step d, page 46 and step e, page 47
Figure 42.
compiled_driver
xaui
xdma
xrawdata
xpmon.exe
UG664_25_052011
43).
Virtex-6 FPGA Connectivity Kit Getting Started
are shown if other
UG664_73_060911
UG664 (v1.4) July 6, 2011