Storage; Terms Of Purchase - Stiga Park Series Instruction Manual

(Translation of the Original Instructions)

11 STORAGE

1. Empty the fuel tank:
• Start the machine's engine and leave it
running until it stops.
2. Change the oil when the engine is still warm.
3. Thoroughly clean the whole machine. It is
particularly important to clean the bottom
side of the cutting device.
4. If the paintwork is damaged, touch it up to
prevent rust.
5. Place the machine in a covered, dry place.
For machines with electric starter:
If the storage temperature is correct, simply
recharge the batter every four months.
Charge the battery before putting the
machine into storage.
The battery can be seriously damaged it if is
put into storage flat.
ENGLISH

12 TERMS OF PURCHASE

The warranty covers all material and manufactu-
ring defects.
The user must follow all the instructions provided
in the accompanying documentation.
The warranty does not cover damages caused by:
• failure to become familiar with the
documentation accompanying the machine,
• carelessness,
• incorrect or prohibited use or assembly,
• use of non-genuine spare parts,
• use of accessories not supplied or approved by
GGP.
The warranty does not cover:
• Normal wear and tear on wear parts such as the
auger, etc..
• normal wear and tear
• engines. Engines are covered by the warranty
provided by the relative manufacturer in
compliance with the specified terms and
conditions.
The purchaser is protected by his own national
legislation. The purchaser's rights envisaged by
the national laws in his own country are not in any
way restricted by this warranty.
EN
23