Checking The Transmission's Oil Level; Checking The Battery Acid Level; Checking The Safety System; Check The Battery - Jonsered FRM13 Automatic Operator's Manual

Check the transmission's oil level

1. Check the transmission's oil level by removing
the transmission cover. Release the two screws
(one of each side) and lift off the transmission
cover.
2. Unscrew the oil cap and check that the oil level
lies between the markings on the dip stick. Top
up if necessary with engine oil SAE 10W/30
(class CD-SF) in the same hole as for the dip
stick.
Check the level of the battery acid
Check that the level of the battery acid lies be-
tween the markings. Top up the cells with only
distilled water.
!
WARNING!
Procedures on contact with acid
External: Rinse well with plenty of water.
Internal: Drink large quantities of water or
milk. Contact a doctor as soon as
possible.
Eyes: Rinse well with plenty of water.
Contact a doctor as soon as possible.
Batteries emit explosive gas. Sparks, flames
and cigarettes must absolutely not be
brought into the vicinity of the battery.

Check the safety system

The machine is equipped with a safety system which prevents starting the cutting unit or driving the machine
unless someone is sitting in the seat.
Check daily the safety system functions.
This check is carried out by applying the parking brake and raising the cutting unit into the transport position.
Start the engine and get off the machine. When the cutting unit is lowered into the cutting position the engine
should stop.
20
– English
MAINTENANCE
FULL