BMW HP4 RACE Rider's Manual page 48

5
46
Evenly push out steering-head
z
bearing at bottom 1 and top 2
using the removal thread 3.
In addition to the steering-
head bearing inserts with 0°
installed by default 1, steering-
head bearing inserts with +/-
0.5° 2 and steering-head bear-
ing inserts with +/- 1° 3 are
also supplied.
Steering head angle ba-
sic setting
Steering head angle insert 0°
Steering head angle ad-
justment range
Steering head angle inserts
+/­ 0.5°; 0.0° and +/- 1°
During the installation, make
sure that two identical the
steering-head bearing inserts
are installed at the top and
bottom and that they are
aligned with the markings on
the frame using the same
values.
Align steering-head bearing in-
sert 1 with the desired angular
offset to the marking 2 on the
frame.
Attach the steering-head bear-
ing insert 1 by hand so that the
alignment tool 3 engages in
the bore on the steering-head
bearing insert 1.
Install steering-head bearing in-
sert 1 in the frame with bearing
draw-in set (83 30 0 444 323).