Jump-Starting - BMW HP4 RACE Rider's Manual

Connect connector 1 to data
logger 2.
Tail section with tank
cover on rear frame
Thread-locking compound:
Loctite 243, Medium-firm
6 lb/ft (8 Nm)
Tail section on rear
frame
Thread-locking compound:
Loctite 243, Medium-firm
6 lb/ft (8 Nm)

Jump-starting

CAUTION
Touching live parts of the ig-
nition system when the en-
gine is running
Electrocution
Do not touch parts of the igni-
tion system when the engine is
running.
ATTENTION
Contact between crocodile
clips of jump leads and mo-
torcycle
Danger of short circuit
Use jump leads fitted with fully
insulated crocodile clips at both
ends.
ATTENTION
Jump-starting with a voltage
higher than 12 V
Damage to the motorcycle's
electronics
The battery of the donor vehi-
cle must not exceed a voltage
of 12 V.
Do not disconnect battery from
onboard electrical system for
jump-starting procedure.
Remove rider's seat (
Remove the screw 1.
Unhook battery carrier 2, lift
and hang to the side.
9
133
38).
z