General Notes; Connections For Additional; Sensors - BMW HP4 RACE Rider's Manual

General notes

10
BMW Motorrad recommends
the use of parts and accessories
144
for your motorcycle that are ap-
proved by BMW for this purpose.
Your authorized BMW Motorrad
retailer is the right place to go
for genuine BMW parts and ac-
cessories,other BMW approved
products, and expert advice on
their installation and use.
These parts and products have
been tested by BMW for safety,
z
function and suitability. BMW
accepts product liability for these
products.
Conversely, BMW is unable to
accept any liability whatsoever
for parts and accessories which it
has not approved.
CAUTION
Use of products from other
manufacturers
Safety risk
BMW Motorrad cannot exam-
ine or test each product of out-
side origin to ensure that it can
be used on or in connection
with BMW motorcycles without
constituting a safety hazard.
Nor is this guarantee provided
when the official approval of
a specific country has been
granted. Tests conducted by
these instances cannot make
provision for all operating con-
ditions experienced by BMW
motorcycles and, consequently,
they are not sufficient in some
circumstances.
Use only parts and accessories
approved by BMW for your
motorcycle.
Connections for
additional sensors
The wiring harness is prepared
for the 2D sensor system cus-
tomary in racing sport.
Front brake pressure sensor
Rear brake pressure sensor
Front spring travel sensor
Rear spring travel sensor
Oil pressure sensor
The connector 1 for the front
brake pressure sensor is located
on the front right of the frame.