Programming Telephony Data; Dial Delay - Northern Telecom Meridian 1 Installation And Maintenance Manual

Verifying that a Base Station is associated with the specified TCM
port
1.
2.
3.
4.
5.
6.
7.

Programming telephony data

Adjust telephony defaults only if instructed to do so via a product bulletin or
other authority. The following telephony values can be changed:
•
•
•
•
•

Dial delay

Dial delay is the time between the selection of an outgoing call line and
transmission of the telephone number's first digit. The delay ensures that dial
Programming the Meridian Companion system Page 79 of 220
Press ƒ••‚ and enter the Installer password.
From A. Configuration , press * until the display shows
C. Maintenance .
Press ^ then * until the display shows
4. TCM status .
Press ^ . The display shows Show TCM: .
You can enter a TCM device number or press ^ to see the first
TCM device.
The display shows T followed by the five-digit device port number and
the device type: BS- 1 (Base Station), RAD, or 7310 (M7310
Administration Terminal).
Press STATE . All BS-1s should be in the Maint state.
Search through TCM devices by pressing * . The display
should reflect the maintenance state. If it does not, refer to
"Troubleshooting a Base Station" on page 177.
Dial delay
B03 gain values
Side tone
CMCC slot
WTN
Meridian Companion Installation and Maintenance Guide