Viewing Radio And Cell Assignments - Northern Telecom Meridian 1 Installation And Maintenance Manual

If there is a serious deployment problem, call Northern
Telecom Customer Response Center at 1-800-321-2649
to verify that you have approval from UTAM Inc. when
initially installing wireless equipment or relocating
wireless equipment. If not, note and proceed.
Failure to receive approval prevents you from enabling
wireless communication on the Meridian Companion system.
You will need to provide the Companion ID each time you are
requesting codes or credits.
A disabled wireless system means that Base Stations and
portables are not operational, but registration information is
retained. These TCM devices may be reactivated by
returning the system to its previous configuration or by
entering a UTAM Recovery Code. A new system is activated
by entering a UTAM Activation Code.

Viewing radio and cell assignments

This procedure checks the integrity of the programming and should occur
immediately after reevaluation.
All radios present on the system should now be assigned to a cell. If any radios
are not assigned to a cell, check the Event/Alarm log to see if any Base Stations
appear defective. Replace if necessary and repeat the reevaluation.
Check to make sure that Base Stations have been clustered into cells as
indicated in the site plan. Add cell numbers and Base Station TCM addresses
to the site plan. If there are inconsistencies, check the wiring to make sure that
Base Stations are wired to the correct port, that the installation matches the
deployment plan, and the site has not changed since the site deployment.
1. Enter Configuration programming.
Press ^ . The display shows 1. Telephony Data .
2.
Press * . The display shows 2. Mobility Data .
3.
Press ^ , then * until the display shows Cells .
4.
Verifying a Meridian Companion installation Page 101 of 220
ATTENTION!
Meridian Companion Installation and Maintenance Guide