Northern Telecom Meridian 1 Installation And Maintenance Manual page 99

Programming the Meridian Companion system Page 89 of 220
‚‚‚‚ .The Installer password must have at least one digit and no more
than six digits.
You should change the Installer password after the system
is installed to protect the integrity of the settings.
To prevent unauthorized access, provide the Installer password
only to selected personnel.
Record any password changes in Meridian Companion
Programming and Provisioning Record . If you forget the Installer
password, you will not be able to enter Programming,
Maintenance, Memory Reset, or System Startup.
Press ƒ••‚ to enter Configuration programming. The
1.
display shows Password: .
2. Enter the Installer password. The display shows A. Configuration.
Press ^ then * until the display shows
3.
3. Admin. Set Data .
Press ^ . The display shows Installer pswd. .
4.
5. Press CHANGE . The display shows New pswd: .
6. Enter a new one- to six-digit Installer password. Use BKSP to correct
your entry if necessary.
7. Press OK . The display shows Re-enter: .
If you do not enter any digits and press OK , the display shows
Pswd not changed .
8. Reenter the digits and press OK . The display shows Password changed.
ATTENTION!
ATTENTION!
Record your password.
Meridian Companion Installation and Maintenance Guide