Does The Display Show Any Of These Messages; Memory Reset - Northern Telecom Meridian 1 Installation And Maintenance Manual

Page 70 of 220 System initialization

Does the display show any of these messages?

Memory Reset

553-3601-200 Standard 7.00 November 1998
The Administration Terminal shows
Station software is downloaded. Some Base Stations may not be powered up
at the same time, so this message may repeat.
If display shows
UTAM code req'd
UTAM test
failed
Config Ambiguous
Memory Reset reinitializes the system, erasing any existing system memory
and resetting it to the factory default values.
Only the installer should perform Memory Reset.
Memory Reset erases all system data and clears all active calls.
The registration information is part of the system data. If this data
is erased, your portables will not work properly.
BS 1 Dload Done
and the system
is a new system
is a previously
initialized system
contains CMBC
ATTENTION!
when all the Base
then
Proceed with programming
as described on page 73.
Apply UTAM Activation
Codes, Portable Credit
Codes and any UTAM
Recovery Codes. You will
also require a new UTAM
Recovery Code before the
system can be brought
online (see "Activating a
disabled system" on
page 150).
See Table 42 on page 183.
Ensure a Base Station is
connected to the CMBC.
See Table 42 on page 183.