Verifying Radio Credits; Troubleshooting A Rad - Northern Telecom Meridian 1 Installation And Maintenance Manual

Page 182 of 220 Troubleshooting

Verifying Radio Credits

Troubleshooting a RAD

553-3601-200 Standard 7.00 November 1998
Press ƒ••‚ and enter the Installer password. The display
1.
shows A. Configuration.
Press ^ . The display shows
2.
Press *
3.
Press ^ . The display shows
4.
Press * . The display shows
5.
Press ^ . The display shows
6.
Press ^ . The display shows
7.
nnn Total
. Verify that the total number of Radio Credits was enough
to support the system you have just installed. If you received a UTAM
message
0 Available
you should have. If you received the
verify the number of Base Stations.
Note 1: The number of Radio Credits must be double the number of Base
Stations you have installed. Refer to Meridian Companion
Programming and Provisioning Record to determine the number of
Base Stations. Each Base Station has two radios, so each Base
Station requires two credits.
Note 2: As each Base Station is initialized, the number of available Radio
Credits will decrease accordingly.
There are two ways to tell if the RAD is not functioning properly.
• If the Administration Terminal can communicate with the Meridian
Companion system but the remote PC cannot, the problem may be due
to a malfunctioning RAD.
• The techniques described in "TCM Status" on page 134 indicate that the
RAD has failed or that the port is not equipped.
.
The display shows
, verify that the total displayed equals what you thought
UTAM test failed
1. Telephony Data
2. Mobility Data
Re-Evaluation
Radios
.
Radio credits
.
nnn Available
.
.
.
and
message,