Northern Telecom Meridian 1 Installation And Maintenance Manual page 26

Page 16 of 220 Installing the hardware
553-3601-200 Standard 7.00 November 1998
Figure 4 : Termination board
RJ11 jack
5. Mount the Base Station onto the bracket, snapping it into position.
6. Connect the power RJ11 jumper lead to the RJ11 jacks on the
termination board and the Base Station.
7. Record the associated port number in the space provided on the printed
label affixed on the lower right corner of the mounting bracket.
Note: Include the labeling information for each Base Station on the
completed installation floor plans and the Meridian Companion
Programming and Provisioning Record for reference.
8. Slide the cover onto the bracket, using the guide to position it properly.
Snap the cover into place.
-PWR(1)
-PWR(2)
CAUTION!
Use UL approved primary and
secondary lightning surge arrestors in
series when installing TCM wiring
outdoors.
Any UL approved primary lightning surge
arrestor may be used, but only an Oneac
model 6-DP or ITW model MP1A-90-27
secondary lightning surge arrestor may be
used.
TCM
TCM
+PWR(1)
+PWR(2)