Rear Wheel Toe–In
After every 800 operating hours or annually, check rear
wheel toe–in.
1. Measure center–to–center distance (at axle height)
at front and rear of steering tires (Fig. 3). Front measure-
ment must be 1/8 in. less than rear measurement.
2. Loosen clamps at both ends of tie rods (Fig. 4).
3. Rotate tie rod to move front of tire inward or outward.
4. Tighten tie rod clamps when adjustment is correct.
NOTE: Make sure tie rod clamps are positioned so they
do not interfere with steering linkage.
Axles and Brakes
Page 6 – 4
Figure 3
2
1
Figure 4
1. Clamp
2. Tie Rod
Reelmaster 4500–D