Toro Reelmaster 4500–D Service Manual page 245

26. Alignment studs can be very helpful in reassembly
of the motor. If you use studs, install 2 studs diagonally
opposed in the bearing housing.
27. Install the shaft face seal in the wear plate as shown
in Fig. 77. Do not distort seal.
28. Install the wear plate, see Fig. 77.
29. Apply a light film of petroleum jelly to the 3[76] diam-
eter seal and install seal in the wear plate.
30. Install the drive into the output shaft.
31. Align the notch on the outside of the Geroler with the
notch on the wear plate. Install the Geroler against the
wear plate. Be sure to retain the rollers in the outer ring
if they are loose.
32. Install the valve drive in the Geroler.
NOTE: Installation at this time involves 3 steps in the
timing of the motor. Timing determines the direction of
rotation of the output shaft. Timing parts include:
1. Geroler
2. Valve Drive
3. Valve Plate
4. Valve
Timing Step #1–Locate the largest open pocket in the
Geroler and mark it on the outside edge of the Geroler.
33. Apply a light film of petroleum jelly to the 3[76] diam-
eter seal. Install seal in groove of valve plate.
34. Align the notch on the outside of the valve plate with
the notch on the Geroler as shown in Fig. 78.
Timing Step #2–Locate the slot opening in the valve
plate which is in line with the largest open pocket of the
Geroler.
Timing Step #3–Locate any one of the side openings of
the valve and align this opening with the open slot of the
valve plate that is in line with the largest open pocket of
the Geroler. Install the valve by rotating it clockwise until
the spline teeth engage (1/2 spline tooth max). This will
provide the proper rotation when pressurized as shown
in Fig. 79.
35. Install 2 springs and 2 pins in the holes located in the
bore of the valve housing, as shown in Fig. 77.
36. Apply a light film of petroleum jelly to the 3[76] diam-
eter seal. Install seal in the valve housing.
Reelmaster 4500–D
Page 4 – 83
Figure 78
Figure 79
Figure 80
Hydraulic System