Toro Reelmaster 4500–D Service Manual page 16

REELMASTER® 450-D and 4500-D Maintenance Schedule
Minimum Recommended Maintenance Intervals:
Maintenance Procedure
Lubricate Reel Control Valve Grease Fitting
Lubricate Reel Speed Control Valve with Oil
Lubricate all Grease Fittings
Check Battery Condition and Connections
‡ Change Engine Oil and Filter
Drain water from Hydraulic Tank
† Check Engine Fan and Alternator Belt
Inspect Cooling System Hoses
Service Air Cleaner Filter Element
Inspect Cutting Unit Reel Drive Belts
† Torque Wheel Lug Nuts
Replace Fuel Filter
Inspect Fuel Lines and connections
‡ Torque Cylinder Head and Adjust Valves
‡ Check Engine RPM (idle and full throttle)
Drain and Clean Fuel Tank
‡ Replace Hydraulic Oil Filter
Replace Hydraulic Tank Breather
‡ Change Front Planetary Gear Lube
Pack Rear Axle Bearings (2wd)
Check Rear Wheel Toe-in
† Initial break in at 10 hours
‡ Initial break in at 50 hours
Replace all Moving Hydraulic Hoses
Replace Safety Switches
Cooling System - Flush/Replace Fluid
Change Hydraulic Oil
See Operator's and Service Manual for specifications and procedures)
Maintenance Interval & Service Type
Every
Every
Every
200hrs
100hrs
50hrs
A Level
Service
B Level
Service
C Level
Service
Annual Recommendations:
Items listed are recommended every 1500 hours
or 2 years whichever occurs first.
:
Every
Every
800hrs
400hrs
D Level
Service
E Level
Service