Toro Reelmaster 4500–D Service Manual page 204

13. Remove quad ring seal from seal gland bushing.
14. Use a thin–blade screwdriver to pry dust seal from
seal gland bushing. Do not damage bushing.
15. Remove 2 bearing races and the needle thrust bear-
ing from spool and sleeve assembly.
16. Remove spool and sleeve assembly from 14–hole
end of housing, see Fig. 33.
Attention: Do not bind spool and sleeve in housing.
Rotate spool and sleeve assembly slowly when re-
moving from housing.
17. Push pin from spool and sleeve assembly.
Hydraulic System
Page 4 – 42
Figure 31
Figure 32
Figure 33
Reelmaster 4500–D