Toro Reelmaster 4500–D Service Manual page 202

Meter (Gerotor) End Disassembly
1. Clamp unit in vise, meter end up. Clamp lightly on
edges of mounting area, see Fig. 25. Use protective ma-
terial on vise jaws. Housing distortion could result if jaws
are over–tightened.
2. Remove 5/16" cap screws.
3. Remove end cap.
4. Remove seal from end cap.
5. Remove meter. Be careful not to drop star.
6. Remove seal from meter.
Hydraulic System
Page 4 – 40
Figure 25
Figure 26
Figure 27
Reelmaster 4500–D