Toro Reelmaster 4500–D Service Manual page 207

6. Bring spring slots of both parts in line and stand parts
on end of bench. Insert spring installation tool through
spring slots of both parts. Tool is available from an Eaton
hydraulics supplier as Eaton part no. 600057. Position
3 pairs of centering springs (or 2 sets of 3 each) on
bench so that extended edge is down and arched center
section is together. In this position, insert one end of en-
tire spring set into spring installation tool, as shown in
Fig. 38, with spring notches facing sleeve.
7. Compress extended end of centering spring set and
push into spool sleeve assembly withdrawing installa-
tion tool at the same time.
8. Center the spring set in the parts so that they push
down evenly and flush with the upper surface of the
spool and sleeve.
9. Install pin though spool and sleeve assembly until pin
become flush at both sides of sleeve.
10. Position the spool and sleeve assembly so that the
splined end of the spool enters the 14–hole end of hous-
ing first, see Fig. 39.
Attention: Be extremely careful that the parts do not
tilt out of position while inserting. Push parts gently
into place with slight rotating action, keep pin nearly
horizontal. Bring the spool assembly entirely within
the housing bore until the parts are flush at the me-
ter end or 14–hole end of housing. Do not pull the
spool assembly beyond this point to prevent the
cross pin from dropping into the discharge groove
of the housing. With the spool assembly in this
flush position, check for free rotation within the
housing by turning with light finger tip force at the
splined end.
Reelmaster 4500–D
Page 4 – 45
Figure 38
Figure 39
Hydraulic System