Selecting A Globrite Light Color And Show Modes Or Fixed Color; Saving A Color Mode Or Fixed Color; Controller - Pentair Pool Products CC50 Owner's Manual

Example: To select California Sunset Mode; turn the switch off and on six (6) successive
times. During the off/on switching process, no illumination will occur, then a white light will
momentarily illuminate.
This operating mode is normal during the switching process. During this
period the pool and spa will be dark and precautions should be taken to
avoid unforeseen accidents. Failure to observe this warning may result in
serious injury or death to pool and spa users.

Saving a Color Mode or Fixed Color

When power is switched off to the GloBrite
color will be saved. The next time the light is powered on, the previously saved color show
mode or fixed color will be displayed. For example, while in "Party Mode" switch the light
off. Wait more than 10 seconds, switch the light back on to resume "Party Mode."
Selecting a GloBrite Light Color and Show Modes or Fixed
Color Using an IntelliBrite
Instead of using a wall switch, GloBrite color lights can controlled with the IntelliBrite

Controller

(p/n 600054, sold separately). The IntelliBrite
Controller provides complete control of your
GloBrite color lights. It's easy to select a lighting
feature, just dial in any one of the pre-programmed
color light shows or fixed colors. Using the Hold
and Recall buttons you can also create endless
unique lighting effects. The IntelliBrite Controller
can be connected to individual or multiple 12 VAC
transformers to control GloBrite color lights. The
IntelliBrite Controller can also control multiple
GloBrite and IntelliBrite lights.
Note: For IntelliBrite controller wiring instructions, see page 18.
Using the IntelliBrite
IntelliBrite colors and shows and can be synchronized with IntelliBrite color lights and
landscape lights. To select a color light show mode or fixed color mode, rotate the dial
so that it points to the desired selection. The color mode selections start in a clockwise
direction from the 9 o'clock position.
Hold and Recall Feature
Hold button/LED: Press this button (LED on) to capture and save a color effect while
displaying one of the light show modes. When the button is pressed, the LED will be on,
indicating that the color effect is captured.
Recall Button/LED: Use this button (LED on) to activate the last saved color effect. When
the button is pressed, the LED will be on, indicating that the color effect is being displayed.
During the off/on switching process, before the
selected color is displayed, no illumination will occur.
®
Color Light Controller: GloBrite color lights are compatible with
®
GloBrite Color Changing LED Pool/Spa Light Installation and User's Guide
Color Lights, the last color show mode or fixed
®
Controller
®
3