Stopping And Starting The Pump; Adjusting And Saving A Pump Speed/Flow; Operating The Pump At Preset Speeds; Pump Operating Modes - Pentair Pool Products CC50 Owner's Manual

Stopping and Starting the Pump

Starting the Pump
1. Be sure the pump is powered on and the green
power LED is on.
2. Select one of the program buttons, then press the
Start/Stop button (LED on) to start the pump. The
pump will go into priming mode if priming feature
is enabled.
Stopping the Pump
1. Press Start/Stop to stop the pump.
When servicing equipment (filters, heaters, chlorinators
etc.), disconnect the communication cable, and switch
OFF circuit breaker to remove power from the pump.
Note: The pump can automatically restart if the com-
munication cable is connected.

Adjusting and Saving a Pump Speed/Flow

While the pump is running, press the Up or Down
1.
arrow to adjust to desired speed or flow setting.
Press and hold down a Program button (1-4) for
2.
three (3) seconds to save speed/flow to the button
or press Save to save the speed/flow.

Operating the Pump at Preset Speeds

The pump is programmed with four default speeds of 750,
1500, 2350 and 3110 RPM. Program buttons 1-4 are for
each of the preset speeds as shown below.
1. Be sure the pump is powered on and the green
power LED is on.
2. Press the Program button (1- 4) corresponding to
the desired preset speed and release quickly. The
LED above the button will turn on.
3. Press Start/Stop. The pump will quickly change to
the selected preset speed.
LED lit
1 2 3 4
INTELLIFLO VSF Variable Speed and Flow Pump Installation and User's Guide
®

Pump Operating Modes

The IntelliFlo VSF Variable Speed and Flow Pump can
®
be programmed in three different modes:
Programs 1-4 can be programmed in all three modes.
Programs 5-8 can only be programmed in Schedule
mode since there are no buttons on the control panel
for Programs 5-8. The default setting for Programs 5-8
is "Disabled".
Manual
Program 1-4
Schedule
Egg Timer
Program 5-8 Disabled
Schedule
Program Menu Tree Options
Manual
Assigns a speed or flow to one of the four Program
buttons on the control panel. This mode can only be
used for programs 1-4. Programs 1 and 2 are Manual
by default.
To operate in Manual mode, press one of the four
program buttons and then press the Start/Stop button.
The pump will run the assigned speed or flow assigned
to that program button.
Egg Timer
Programs 1-4 can be programmed to run at a certain
speed or flow and for a duration of time once a program
button is pressed.
Programs 3 and 4 are Egg Timers by default. If you
desire a different method of operation, programs 3 and
4 can be changed to Manual mode in the control menu.
To operate in Egg Timer mode, press a program button
and then press Start/Stop. The pump will run that
setting for the set amount of time and then turn off.
Schedule
Programs 1-8 start and stop at a specific time during a 24
hour period. Speeds or flows programmed in Schedule
mode will override any manually selected speed or flow
once the next Schedule command commences.

Program Types

This pump can run saved programs at either constant
speeds or constant flow rates. This gives the user the
ability to precisely assign the output from the pump
so that no energy is wasted and the job is completed
accurately.
7
Set Type Set Speed
Set Flow Set Flow
Set Type
Set Speed
Set Flow Set Flow
Set Start Time
Set Stop Time
Set Type
Set Speed
Set Flow Set Flow
Set Duration
Default: Disabled
Set Type
Set Speed
Set Flow Set Flow
Set Start Time
Set Stop Time