Table of Contents
Advertisement
Tools Required
• Hand or Electric Drill
• Air Pressure Gauge
• Pencil
• Tape Measure
• Utility Knife or Tube Cutter
(for plastic tubing)
NOTE: Not all tools listed may be necessary for installation.
Read installation procedures before starting to
determine required tools.
SELECTING A MOUNTING LOCATION
1. Give consideration to the weight of the unit when
operating, i.e. when filled with water. Operating weight of
the Everpure
Conserv
®
• 53 lbs (24 kgs)
2. The location should allow for:
• The Conserv 75S System may be wall mounted or set
on its base .
• Adequate space for "in" and "out" water line
connections.
• Be near a drain for flushing.
• Accessible to a 100 - 240 Vac/50/60 Hz AC wall plug.
3. The inlet water supply must meet the requirements listed
in the section "Operating Specifications".
DIMENSIONS
10.20 in
(259 mm)
Figure 1
2
EVERPURE
CONSERV
®
• Phillips Screwdriver
• Towel
• Safety Glasses
• Drill Bits: 1/8", 1/4" and
3/8"
75S System is approx.:
®
16.95 in
(431 mm)
18.70 in
(475 mm)
75S HIGH EFFICIENCY RO SYSTEM INSTALLATION AND OPERATION GUIDE
®
SAFETY INSTRUCTIONS
NOTE: This appliance can be used by children aged
from eight (8) years and above and persons
with reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given supervision
or instruction concerning use of the appliance
in a safe way and understand the hazards
involved.
NOTE: The appliance is only to be installed in
locations where its use, maintenance and
cleaning is restricted to trained adult
personnel. No one should play with the
appliance.
NOTE: Children should be supervised to ensure that
they do not play with the appliance.
NOTE: Cleaning and user maintenance shall not be
made by children without supervision.
NOTE: The appliance is not suitable for installation in
an area where a water jet could be used.
NOTE: If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
WARNING: Installation shall comply with applicable
local, state, and national plumbing and
electrical regulations.
WARNING: This appliance must be grounded. This
appliance is equipped with a cord having
an appliance-grounding conductor and a
grounding plug. The plug must be plugged
into an appropriate outlet that is installed
and grounded in accordance with all
local codes and ordinances. If the supply
cord is damaged, it must be replaced by
the manufacturer, its service agent or
similarly qualified persons in order to
avoid a hazard.
WARNING: Improper connection of the appliance-
grounding conductor can result in a risk
of electric shock. Check with a qualified
electrician or service representative if
you are in doubt whether the appliance is
properly grounded. Do not modify the plug
provided with the appliance; if it will not fit
in the outlet, have a proper outlet installed
by a qualified technician.
WARNING: The appliance is intended to be
permanently connected to the water mains
and not connected by a hose-set. The
appliance is not suitable for installation in
an area where a water jet could be used
and must not be cleaned by a water jet.
Advertisement
Table of Contents
