Setting Priming Features; Disabling Priming With An Automation System - Pentair Pool Products CC50 Owner's Manual

MENU
Pump Menu: Priming
PRIMING

Setting Priming Features

1. Press Menu.
2. Use Down arrow to scroll to "Priming" and press
Select.
3. The factory default is set to priming "Enabled". To
disable, scroll to "Disabled" and press Select.
Note: All priming features are only accessible if
priming is "Enabled".
4. Press Save if you have changed the setting - this
will save the selection.
5. Press the Down arrow to scroll to "Set Speed".
Press Select to edit.
6. Use the Up or Down arrows to change the speed
settings. Press Save.
7. Press the Down to scroll to "Max Priming Duration".
Press Select to edit.
8. Use the Up or Down arrows to change the time
from 1 minute to 30 minutes. Press Save.
9. Press the Down arrow to scroll to "Priming Range".
Press Select to edit.
10. Use the Up or Down arrows to change from 1 to
10. Increasing the number allows the drive to detect
prime with less water flow.
11. Press Save.
12. Press the Down arrow to scroll to "Priming Delay".
Press Select to edit.
13. Use the Up or Down arrows to change from 1
second to 10 minutes. Press Save.
Increasing the time causes the pump to
stay in the priming mode longer.
1. Disable priming on automation control system.
3. Disable priming on pump.
14. Press the Down arrow to scroll to "Loss of Prime".
15. The factory default is "Enabled". To disable, press
Select to edit and use the Down arrow to scroll to
"Disabled". Press Save.
16. Press Back to exit the priming menu.
Disabling Priming with an Automation
System
When the IntelliFlo
Pump is connected to an automation control system,
(IntelliTouch
Systems), the priming feature on the pump cannot be
disabled by the external automation control system
only. It must also be disabled on the pump itself.
If priming is enabled on start up, the pump responds
to its internal settings before responding to commands
from an automation control system.
If the pump is connected to an automation control
system and priming is not desired, disable the priming
feature on both the pump and the automation control
system.
To disable priming with an automation system:
1. Disable the priming feature on the automation control
system at the load center or using an IntelliTouch or
EasyTouch system remote. (Refer to the automation
control system user's guide for additional information).
2. Temporarily disconnect the RS-485 communication
cable.
3. Open the lid to the control panel to disable priming
on the pump. Press Menu, use the Arrow buttons to
scroll and select "Priming", then select "Disabled"
(the factory default is set to "Enabled"). Press Back
to exit the menu.
4. Once priming is disabled, reinstall the RS-485
communication cable.
2. Disconnect the RS-485 communication cable.
4. Reinstall the RS-485 communication cable.
INTELLIFLO VSF Variable Speed and Flow Pump Installation and User's Guide
®
® VSF Variable Speed and Flow
, EasyTouch or SunTouch
® ®
19
Control
®