Set Pressure Limit For Speed Program; Pump Address; Set Screen Contrast; Set Control Panel Language - Pentair Pool Products CC50 Owner's Manual

12
MENU
Pump Menu: Settings
SETTINGS

Set Pressure Limit for Speed Program

While Pressure Limit is active whenever the pump is
operating a Flow type of program, the pressure limit is
disabled by default when running the pump in a constant
speed mode. Enabling this feature will make sure that the
drive is monitoring the system pressure when operating
in constant speed mode also.
1. Check that the green power LED is on.
2. Press Menu.
3. Press Select to select "Settings".
4. Use the Up or Down arrows to scroll to "Min/Max".
Press Select.
5. Use the Up or Down arrows to scroll to "Press Limit
(Speed)".
6. Press Select to move the cursor over the "Disabled".
7. Press and the Up or Down arrows to change it to
"Enabled".
8. Press Save to save. To cancel, press Back to exit
edit mode without saving.
9. Press Back to exit.

Pump Address

Use this setting if your pump is connected via the RS-485
COM port to a Pentair automation system.
The default pump address is #1 and only needs to be
changed when there is more than one pump on an
automation system. Change the address to allow the
automation system to send a command to the correct
pump. The pump address can be set from 1-16.
Refer to the automation system manual for further
details on how to connect and use an automation
system with your variable speed pump.
1. Be sure the green power LED is on and the pump
is stopped.
2. Press Menu.
3. Press Select to select "Settings".
4. Use the Up or Down arrows to scroll to "Device".
Press Select.
5. Use the Up or Down arrows to scroll to "Pump
Address". Press Select.
6. Press Up or Down arrows to change the address
number from 1-16.
7. Press Save to save. To cancel any changes, press
Back to exit without saving.
8. Press Back to exit.
INTELLIFLO VSF Variable Speed and Flow Pump Installation and User's Guide
®

Set Screen Contrast

The default contrast setting for the LCD screen is 3.
Screen contrast levels can be adjusted from 1 to 5
units for low or high lighting conditions.
Note: Changes to the contrast setting do not update
instantaneously. Changes to this setting must be saved
before the contrast level changes.
1. Check that the green power LED is on.
2. Press Menu.
3. Press Select to select "Settings".
4. Use the Up or Down arrow to scroll to "Device".
Press Select.
5. Use the Up or Down arrow to scroll to "Contrast
Level."
6. Press Select. Screen will show current contrast
setting number. Use Up or Down to change
number.
7. Press Save to save. To cancel any changes, press
Back to exit without saving.
8. Press the Back button to exit.

Set Control Panel Language

To access the language menu:
1. Check that the green power LED is on.
2. Press Menu and press Select to select "Settings".
3. Use the Up or Down arrows and scroll to "Device".
Press Select.
4. Use the Up or Down arrows to scroll to "Select
Language". Press Select.
5. Use the Up or Down arrows to choose the desired
language.
6. Press Save to select the control panel language. To
cancel any changes, press Back to exit without saving.
7. Press Back to exit.

Set Temperature Unit

The default setting is Fahrenheit (°F). The pump can be
set to either Celsius (°C) or Fahrenheit (°F).
1. Check that the green power LED is on.
2. Press Menu.
3. Press Select to select "Settings".
4. Use the Up or Down arrows to scroll to "Device"
menu item. Press Select.
5. Use Up or Down arrows to scroll to "Temperature
Units". Press Select.
6. Use Up or Down arrows to choose Celsius (°C) or
Fahrenheit (°F).
7. Press Save to save. To cancel any changes, press
Back to exit without saving.
8. Press Back to exit.