Pentair Pool Products CC50 Owner's Manual page 20

8
To 12 VAC
Transformer
Ridgid
2.54 cm (1 in)
Conduit
Figure 2: Gunite Light Installation Diagram
Installing GloBrite
To install the GloBrite color light niche in a fiberglass pool:
1. Drill or punch a 5 cm (2 in) hole in the desired location for the GloBrite light
niche.
2. Place the sealing gasket on the niche as shown below.
3. Insert the niche through the 5 cm (2 in) hole in the pool wall.
4. Install the PVC washer to the back of the niche.
5. Install the plastic nut onto the back of the niche. Hand tighten the nut to
secure the niche in place.
6. Glue the 2.5 cm (1 in) conduit into back of niche.
2.54 cm (1 in) Conduit
GloBrite Color Light Niche (Fiberglass pool) Installation Diagram
1.22 m (48 in) minimum
10.2 cm (4 in)
Niche Sleeve: 5.08 cm (2 in) PVC Pipe
35.1 cm (15 in)
®
Color Light Niche in a Fiberglass Pool
Niche
For Gunite Niche Only
Pool wall
Nut
PVC washer
(20.3 cm (8 in)
USA: 10.2 cm
Canada: 600 mm max.
(4 in) to top of
to centerline of the Lens
lens
Niche Sleeve
(cut flush to wall
before plastering)
Color Ring and Gunite Cover
Plaster Finish
Sealing gasket