Pentair Pool Products CC50 Owner's Manual page 22

10
INSTALLING THE GLOBRITE
To install the GloBrite color light into the gunite, fiberglass or vinyl niche:
1. Route the GloBrite light power cord through the front of the niche, to the
location of the 12 VAC pool transformer or junction box.
2. At the 12 VAC transformer or junction box, cut off any extra cord. Leave
at least 15.2 cm (6 in) of cord in the Junction Box or transformer to
facilitate the light installation, niche inspection. Cut off any extra cord.
See Figure 2 on page 8. For junction box installation for Canada, see
Figure 1 on page 5.
3. Strip back the outer cord jacket of the wires to expose the two (2) insulated
conductors. Strip back the two conductors. Be careful not to damage the
copper conductor.
4. Connect the two (2) conductors to the corresponding circuit wires in the
Junction Box (black wire to power, white wire to common). Secure the
Junction Box cover.
5. Install the new GloBrite light assembly: Push the light into the niche
while pulling the power cord from the junction box or transformer, making
sure the locking tabs in the back end of the light are properly aligned with the
niche openings (inside the niche).
Light niche
(gunite niche
shown)
(AFTER NICHE INSTALLATION)
Locking tabs
Light power cord
GloBrite Niche and Light
®
WHITE LIGHT ASSEMBLY
Rubber seal
(back of light)
Light assembly