GEM 533 eSyStep Operating Instructions Manual page 35

12.4.21 Calibration Positions
The values of the factory calibration can be read out with the Calibration Positions parameter.
The values are analogue values of the potentiometer in the mechanical end positions of the actuator.
In- Sub- Off- Access
dex In- set Rights
dex
0x55 1 RO
2 RO
Description of parameter values
Parameter
Max.
Min.
12.4.22 Cycle Counter
Switching cycles of the actuator or of the valve are counted with the Cycle Counter parameter.
For a switching cycle, end position OPEN and then end position CLOSED must be detected. This also means that cycles are not
counted for a programming/initialization error.
In- Sub- Off- Access
dex In- set Rights
dex
0x56 0 R/W
1 R/W
2 RO
Description of parameter values
Parameter
User 0 to 16,777,215
Total 0 to 16,777,215
12.4.23 AD-Values
Different analog values can be read out with the AD-Values parameter.
Index Sub- Off-
Index set
0x60 1
2
3
4
Description of parameter values
Parameter
Potentiometer
Supply Voltage
Temperature
Set value input
www.gemu-group.com
Length Parameter
12 bits Max.
12 bits Min.
Values
0 to 4092 Read out analogue value of the potentiometer for the mechanical end position
OPEN.
0 to 4092 Read out analogue value of the potentiometer for the mechanical end position
CLOSED.
Length Parameter
Cycle Counter
24 bits User
24 bits Total
Values
The User counter can be reset, for example, after maintenance.
The Total counter cannot be reset.
Access Length
Rights
RO 12 bits
RO 12 bits Supply Voltage
RO 12 bits
RO 12 bits Set value input
Values
0 to 4095 Read out current analogue value of the potentiometer.
0 to 4095 Read out current analogue value of the supply voltage.
0 to 4095 Read out current analogue value of the temperature sensor.
0 to 4095 Read out current analogue value of the set value.
Type
uint:16
uint:16
Description
Type
uint:24
uint:24
Description
Parameter Type
Potentiometer uint:16
uint:16
Temperature uint:16
uint:16
Description
35 / 52
12 Specific data IO-Link (pin 6)
Default Values
0 0 to 4092
4092 0 to 4092
Default Values
0 0 to 16,777,215
0 0 to 16,777,215
Values
0 to 4095
0 to 4095
0 to 4095
0 to 4095
Positioner (Code S0)
GEMÜ 533