GEM 533 eSyStep Operating Instructions Manual page 33

12.4.18 Basic Settings
The different settings are summarized with the Basic Settings parameter.
In- Sub- Off- Access
dex In- set Rights
dex
0x50 1 0 R/W
2 1 R/W
3 1 R/W
4 3 R/W
Description of parameter values
Parameter
Inversion of LED
Colours
On Site Initialization
Operating Mode
IO-Link Process
Data
www.gemu-group.com
Length Parameter
1 bit Inversion of
LED Colours
1 bit On Site Initialization
1 bit Operating Mode
1 bit IO-Link Process
Data
Values
0 (Standard) LEDs Close = green and Open = yellow (not inversed).
1 (Inversed) LEDs Close = yellow and Open = green (inversed).
0 (Enabled) On-site initialization (see "Initialization", page 43) activated.
1 (Disabled) On-site initialization (see "Initialization", page 43) deactivated.
0 (Positioner) The actuator is in positioner mode.
1 (OPEN/CLOSE) The actuator is in OPEN/CLOSE mode.
0 (Disabled) Use of IO-Link process data (see "Process data", page 23) is
deactivated.
1 (Enabled) Use of IO-Link process data (see "Process data", page 23) is
activated.
Type Default
Boolean
Boolean
Boolean
Boolean
Description
33 / 52
12 Specific data IO-Link (pin 6)
Values
0 0
1
0 0
1
0 0
1
0 0
1
Positioner (Code S0)
GEMÜ 533