Troubleshooting
Tyre pressure display faulty
flashes for about 1 minute and stays on
›
Stop the car, turn the ignition off and on again.
If the symbol
flashes again after turning on ignition, there is
a system fault.
›
Continue driving, exercising appropriate caution, and seek the
help of a specialist garage.
Wheel bolt cover caps
Remove cover caps and install
Disconnecting
›
Push the pull-off clamp onto the
cover cap up to the stop.
›
Remove the cover cap.
Installing
›
Push the cover cap onto the wheel bolt to the stop.
Wheels ›
Full wheel frame
Removing and installing the trim
Applies to factory built or original accessory trims from ŠKODA.
Disconnecting
›
Hang the clamps for removing the wheel trims at the edge of
one of the openings in the trim.
›
Push the wheel wrench through the clamp, support on the tyre
and pull off the wheel trim.
Installing
›
Press the wheel trim onto the wheel rim at the designated
valve opening.
When using an anti-theft wheel bolt, it must be located at the
location indicated on the bezel.
›
Press the trim, starting at the valve, into the rim on both sides
until it engages around the entire circumference.
NOTICE
Use hand pressure, do not hit the wheel cover.
▶
Wheel bolt cover caps
231