Table of Contents
Advertisement
208 High-voltage system ›
Universal charging cable
Connect the replaceable charging cable to the control box
›
Insert the plug
control box.
›
Open the cover cap
›
Insert the plug
go.
›
Close the cover cap
›
Screw in the screw
Start the charging process
›
Fully unwind the charging cable and connect it to the charger
socket or to a standard mains socket.
All indicator lights briefly light up red.
›
Insert the charging cable plug into the charging socket.
The on / off indicator lamp lights up yellow. After a successful
self-test, all indicator lights light up green for two seconds.
The charging process starts automatically.
Further information can be found in the chapter Load-
ing
» page 197,
partially into the
B
.
A
Troubleshooting
The plug for the power supply connection is overheated
The indicator light
charging current is limited. After cooling down, the error is auto-
matically fixed and the charging process continues.
›
If the problem persists, seek the help of a specialist garage.
Standard mains socket is overheated
as far as it will
B
The indicator light
charging current is limited. After cooling down, the error is auto-
.
A
matically fixed and the charging process continues.
.
C
›
Have the power supply checked immediately by a specialist
garage.
Power supply is limited
The indicator light
charging process is interrupted. After the power supply stabili-
zation, the error is automatically remedied and the charging
process continues.
›
Have the power supply checked immediately by a specialist
garage.
Power grid is overloaded
The indicator light
charging process is interrupted.
›
Disconnect the charging cable and reconnect after 60 s.
›
Have the power supply checked immediately by a specialist
garage.
Charging.
pulsates green and
lights up yellow. The
lights up in red and
lights up yellow. The
lights up in red and
flashes yellow. The
lights up in red and
flashes red. The
Advertisement
Table of Contents
